There are two main types associated with aluminum radiators: high-pressure solid aluminum and stretched metal alloy welding. The main advantages are:
①Aluminum radiator has greater heat dissipation performance and its energy-saving characteristics have grown obvious. In the exact room, if the radiator on the same specification is used, the number of aluminum castings is less than that of steel.
②The aluminum profile radiator possesses good oxidation and corrosion resistance and will not need to add any additives. The principle is once aluminum encounters oxygen in the air, an oxide roll film is formed. This motion picture is tough and heavy, preventing further damage for the body material. Corrosion.
Choose aluminum radiator, it is best to choose high-pressure cast aluminum module combined radiator. This radiator is integrally formed by die-casting on one occasion, so there is not a problem of weld leakage. And its biggest advantage could be that the product is not restricted through the district heating system, even inside the open boiler system, it cannot be corroded by oxygen. As a result of modular design, after your heating season, if the indoor temperature is found for being insufficient, it is still You can install a couple more pieces in cost-free year to meet your own personal needs, instead of replacing the entire set of heaters for a steel radiator.
In supplement, because aluminum radiators have different requirements for drinking water quality than steel, it can be crucial to avoid mixed installment of aluminum radiators with other materials.
First coming from all, please unpack the metal radiator first, and install mid-air release valve and your union first.
2. The position belonging to the hole for installing the special hook is often drawn on the wall in line with the provided installation drawing or related requirements.
A FEW. When installing aluminum radiators, think about the damage caused by this thermal expansion and contraction in the heating pipe to this radiator. [1"> 4. Position the 12 expansion tube in and level it.
5. Use a percussion drill to drill a target of 12, the depth of which is after the expansion tube is place in, and the outer edge in the hole should be flush while using wall.
6. Install the underside hook, and tighten the screws after reaching what's needed.
7. Place the aluminum radiator on the hook that was installed at the bottom level, install the upper land to adjust the position with the hook, and then tighten the actual expansion screw after it can be clamped. When placing that radiator, place the air release valve for the top.
8. After installing and assembling the water pipe joints, install the pipes and connect them towards the water inlet and outlet reported by the drawings, and fasten them everywhere. The back side is 3. 5cm away from the wall and 5cm from the kick line.
HUNTING FOR. Please input hot water, open the bleed control device, and bleed until water comes out. When that aluminum radiator is running, the working pressure indexed by the manual must definitely not exceed 0. 12Mpa.
TEN. The oxygen content inside heat medium shall definitely not exceed 0. 05g a square meter. The medium water used for the radiator should meet PH9≤9, and PH≤12 when you will find internal anti-corrosion measures.
https://www.metalplustech.com/aluminum-heat-sink-pl3896103.html 201911ld